We have Permanent Opportunity for Lead Process Engineer/Process Engineer FOR Bangalore MNC

Ex-8-15yrs

Looking only immediate to max 30days notice period

Process Specialist:

To prepare/ review/ check/comment following type of documents

- Process Design Basis

- Process basic calculations (HMB consistency check - mass, molar and energy balance); Process engineering calculations (line sizing, pump hydraulics, equipment sizing); References for calculations, physical properties,, Pinch study & analysis of energy conservation Opportunities; Pump and compressor head calculations; PSV and safety devices; PSV scenario identifications and calculation of respective relieving capacity; Flare Header sizing; etc)

- Engineering drawings like PFDs, MSDs and P&IDs

- Line lists to support P&IDs (inclusive of operating and design conditions, test pressure, insulation requirement with thickness); Tracing & insulation requirements.

- Materials inventory and usage summary;

- Equipment datasheets - like reactors, vessels, tanks, columns, heat exchangers, pump, compressor, filters, mixers, agitators, packages, etc

- Input to hazardous area classification drawings

- Environmental loads and treatment

- Noise Protection requirements

- Process Hazard Analysis (PHA)

- Basic Process Control System.

- Aspen/hysys

- Mass and Heat calculation

- Process Design Calculation

- Methods followed in Equipment datasheets - like reactors, vessels, tanks.

- Calculation in detail engineering

- Feed process( from conceptual design knowledge to execution ) questions

- Related P&D, PID

Required Skills (Technical Competency):

- Bachelor's / Master's Degree in Engineering or related discipline.

- 8+ Years of proven experience as a process engineer.

- Front end engineering design (FEED)

Desired Skills:

- Utility, Chemicals Requirements, and Waste Summary

- Flare system Design (flare KOO, water seal drum, flare stack sizing);

- Analytical and Operating Manuals

- Design basis, PFD, P&ID, HMB, Hydraulic Calculations, Equipment Sizing,

- Instrument Datasheets, Relief Load Calculations, DPDT, Process Simulation,

- FEED, Detailed Engineering, Revamp.

Skills Total Years of Exp.

How many years worked on Line Sizing : 
How many years worked on Velocity : 
How many years worked on Process Design Calculation : 
How many years in methods followed in Equipment datasheets - like reactors, vessels, tanks.
How many years worked on detail engineering : 
Did u worked from Feed process( from conceptual design knowledge to execution ): 
How many years worked on P&D, PID :
How many years worked in software Aspen/hysys : 
Mass and Heat calculation :
what about this erosional velocities? Do you check erosional velocities?
Did u worked on Designed in real time project.
Did u life cylce in simulation from the scratch :
Number of stages in in simulation you status, number of stages right.
Wt about Hazop :
How are you developed the PFD? Yeah. :
Knowledge in cooling and heating you are using different regeneration gaps.
How many years the calculation on Pump Stream : 

 
Please mention the details mentioned below or references can share cv 

Name (As per Adhaar Card)-
Experience-
Relevant Exp-
Ctc-
Ectc-
Notice Period-
if in Serving, LWD -
Current Company-
Payroll Company-
Designation-
Qualification-
Current Location-
Preferred Location-

Rekha Rai
Senior Consultant-Peple Success
Orcapod

This job opening was posted long time back. It may not be active. Nor was it removed by the recruiter. Please use your discretion.